电压不在额定范围之内，环境温度过高。恢复至额定电压。降低房间温度, 避免阳光直射, 否则有可能发生极度过热。调整到适当压力, 增大供油量,分解清洗。电磁阀粘住,使用压力过高,电磁铁有过电流通过。
The voltage of the laser concrete leveling machine is not within the rated range, and the ambient temperature is too high. Restore to the rated voltage. Reduce room temperature and avoid direct sunlight, otherwise extreme overheating may occur. Adjust to appropriate pressure, increase the amount of oil supply, decompose cleaning. The solenoid valve is stuck, the use of the pressure is too high, and the electromagnet is passed through the current.
激光混凝土整平机电气回路出问题，主管压力不足解决方法，更换继电器的接头。因为当电磁铁通电时, 如果继电器的接点接触不良、接点粘连, 就有可能造成线圈烧毁。加大气源压力以确保先导式电磁阀正常动作所需压力。
The electrical circuit of the laser concrete leveling machine is out of problem, the pressure of the supervisor is not enough to solve the method, and the relay is replaced. Because when the electromagnetic iron is electrified, if the contact contact of the relay is bad and the contact contact, it is possible to cause the coil to burn down. Increase the pressure of the gas source to ensure the pressure required for the normal operation of the pilot solenoid valve.
The vibration of the solenoid valve of the laser concrete leveling machine is analyzed. The use of low voltage electromagnet of face of a foreign body, short circuit or bad link ring commutator. Return to normal voltage. Because the low voltage will not produce the necessary attraction, the relationship between the recovery of the resilience and the attractiveness causes the vibration. Remove the foreign body and scrape the uneven suction surface. Repair or replace parts.
选择合适的激光混凝土整平机先导式电磁阀;重新调节调压阀, 以提高压力加强对冷凝水的管理。因为混入的冷凝水会腐蚀已作过防锈处理的弹簧, 使其寿命缩短. 有时甚至折断。在更换弹簧的同时除去冷凝水。
Select the proper guide type solenoid valve of the laser concrete leveling machine, and adjust the pressure regulating valve to improve the management of the condensate. Because the mixed condensate will corrode the springs that have been antirustproof, shorten their life and sometimes even break. The condensate is removed while the spring is replaced.